Listen to the following passage. Write in English a short summary of around 150 words of what you have heard on the ANSWER SHEET

Listen to the following passage. Write in English a short summary of around 150 words of what you have heard on the ANSWER SHEET. This part of the test carries 30 points. You will hear the passage only once. At the end of the recording, you will have 25 minutes to finish this part. You may need to scribble a few notes to write your summary.
   Auto restoration is an amazingly popular and can become a passion for those with plenty of time, heaps of determination and of course, the money to rejuvenate an old vehicle back to its youthful vitality and splendor. These are the basic steps you will need to work through:
   1. The Right Vehicle
   You may already have a vehicle to work on, but if buying one particularly for restoration keep in mind that sourcing parts for the rare makes will be more difficult and more expensive. Classic cars of the 50’s and 60’s are popular models for restorers, but any model can be re-built with time and patience.
   2. Tools
   As restoration involves much more than making the exterior look good, you will need all the right tools from the wide range of them; including torque wrenches, hammers, as well as those for the specialist jobs of welding, polishing and painting. Almost every part will need replacing to produce a traditionally accurate and fully operating vehicle.
   3. Interior Cleaning
   The amount of work needed will depend on the condition of the vehicle. Clearly you may find in a junkyard will naturally need lots more muscle than one that has been garaged by a dedicated owner. The car may need entirely re-upholstering, perhaps new seats are needed or the dashboard gauges will need replacing and an original radio to be located.
   4. Out with the Vacuum
   A total vacuum of the interior after taking out the inside door panels and floor panels. Remove the seats and use a solvent or cleaning fluid to meticulously clean the inside. Allow time for drying thoroughly before replacing with new parts, or used ones sourced from scrap yards or online outlets.
   5. Out with Old
   All rust needs to be totally eliminated and is present in almost all restoration jobs. Sometimes it is more economical to buy new exterior parts than try to remove the rust. In some cases a piece may need to be cut out to remove the rust and a new section welded in.
   6. In with the New
   After removing the paint, the panels need a coating of an epoxy primer before the final painting. Finally each piece can be replaced in the car.
   7. All Those Extras
   Other exterior parts need close inspection to decide if they need either replacing or repairing. Look at the windshield, head and tail lights, mirrors, door handles and hood latches and all other small fittings.
   8. Most Important
   The all-important engine needs careful attention and is really one of the most important jobs in restoration, the engine needs to be dismantled; it all has to go, part by part. The carburetor, compressor, cylinder heads and fuel pump need to be checked and allocated to the replacing or repairing category.
   9. Decisions
   Depending on your needs, the engine can be rebuilt with original parts to build a valuable authentic vehicle, but there’s also the option of installing a completely new and modern engine if the car is more your personal assignment.
   Restoration is not an easy task and the difficulty of completing an entire assignment is not to be underestimated - it is truly a work of dedication.